Brekeke Forum Index » Brekeke PBX Forum

Post new topic   Reply to topic
Stop PBX pass thru #8 call park
Author Message
voipwell.com
Partner PBX


Joined: 20 Sep 2005
Posts: 528
Location: Tannersville, Pennsylvania

PostPosted: Thu Jul 16, 2015 11:09 am    Post subject: Stop PBX pass thru #8 call park Reply with quote

1. Brekeke Product Name and Version:

2. Java version:

3. OS type and the version:

4. UA (phone), gateway or other hardware/software involved:

5. Your problem:
Network Setup: IP Phone --->V3 PBX --->V2 PBX --->SIP Carrier
IP Phones use


When a user in V3 enters #8 on ip phone endpoint Both v3 and v2 act on it. Is there a way to prevent the pass thru of #8 from v3 pbx to v2 pbx. Using rfc2833 for dtmf because carrier requirement. Thanks!
Back to top
View user's profile
voipwell.com
Partner PBX


Joined: 20 Sep 2005
Posts: 528
Location: Tannersville, Pennsylvania

PostPosted: Wed Jul 22, 2015 10:37 am    Post subject: Change #8 to #4 or another digit call park Reply with quote

Is it possible to change the built in key for call park to something other than #8? #5 for example?
Back to top
View user's profile
llucy
Brekeke Talented


Joined: 31 Jan 2014
Posts: 52

PostPosted: Tue Aug 11, 2015 10:50 am    Post subject: Reply with quote

This is not official way but you can add a property like below at Options > Advanced.

fw.com.brekeke.pbx.fw.talker.User.COMMAND_TRANSFER=DTMF:#9;TIME:1500;COMMAND:TRANSFER,DTMF:#5;TIME:1500;COMMAND:PARK2,DTMF:#0;TIME:1500;COMMAND:CONF,DTMF:#7;TIME:1500;COMMAND:CONF_SILENT


It would not be better to apply a PBX user to the calls at V2 PBX so the call won't be parked at V2 PBX.

Lucy
Back to top
View user's profile
voipwell.com
Partner PBX


Joined: 20 Sep 2005
Posts: 528
Location: Tannersville, Pennsylvania

PostPosted: Thu Aug 13, 2015 1:54 pm    Post subject: Reply with quote

Lucy,

Thank you very much for your response. Can i use this string in either v2 or v3?

For others reading this post i reformatted the answer to make it easier to read. It appears the commas are the delimiter.

Park changed from #8 to #5:

fw.com.brekeke.pbx.fw.talker.User.COMMAND_TRANSFER=
DTMF:#9;TIME:1500;COMMAND:TRANSFER,
DTMF:#5;TIME:1500;COMMAND:PARK2,
DTMF:#0;TIME:1500;COMMAND:CONF,
DTMF:#7;TIME:1500;COMMAND:CONF_SILENT
Back to top
View user's profile
Display posts from previous:   
Post new topic   Reply to topic    Brekeke Forum Index » Brekeke PBX Forum All times are GMT - 7 Hours
Page 1 of 1