Author |
Message |
new4new Brekeke Junior Member
Joined: 30 Apr 2008 Posts: 6
|
Posted: Wed Apr 30, 2008 6:15 am Post subject: what best for me? |
|
|
Hi
it's now 2 week searching for windows SIP server ..finally i found brekeke ..i want to make server can connected client form external network (WAN) and there users can connected to VoIP like broadVoice via this server
what's application best for this issue?
I have downloaded PBX server and SIP server and test both
first i tested PBX and maked two user's with ID 1001 and 1002
the server on windows 2003
and used softphone on other 2 computer
the problem when first one call other it's tell me not avilable when i canceled voice message from user setting i have get
Other side said: Too Many Hops
i deleted user's and swiched to SIP server and maked two user
no problem two user can call each other ..but how can add external line these user can call VoIP line?
what's problem |
|
Back to top |
|
hope Brekeke Master Guru
Joined: 15 Jan 2008 Posts: 862
|
|
Back to top |
|
new4new Brekeke Junior Member
Joined: 30 Apr 2008 Posts: 6
|
Posted: Wed Apr 30, 2008 3:57 pm Post subject: |
|
|
ok i will use Brekeke PBX is it mean no need to use SIP server ?
my Brekeke PBX is last version 2.1 and network pattern here
http://www.brekeke-sip.com/bbs/network/pattern5.GIF
but when i created 2 users with ID 1001 and 1002 both out side public IP (both in different lan)(WAN users)
2 extention not connect to each other ..i call 1002 number or 1001?
is there any special prefix?
what's wrong ? |
|
Back to top |
|
new4new Brekeke Junior Member
Joined: 30 Apr 2008 Posts: 6
|
Posted: Wed Apr 30, 2008 5:26 pm Post subject: |
|
|
the problem solved
the problem now why any number registered in softphone why not brekeke pbx check password and userid
if i put any id it will be register on SIP server how and why? |
|
Back to top |
|
hope Brekeke Master Guru
Joined: 15 Jan 2008 Posts: 862
|
Posted: Thu May 01, 2008 9:26 am Post subject: |
|
|
Brekeke PBX already include SIP Sever in. No another SIP server needed.
If you want to check UA's (phones) username and password when they register to PBX, you need to set the same username and password as the ones you set at phone side at SIP Server/User Authentication and also set authentication for register ON at SIP Sever/Configuration/SIP/Authentication/
the detail is in page 16 of Brekeke document below
http://www.brekeke-sip.com/download/bss/v2_1/sip_admin_en.pdf
and the difference of username and pw in pbx and sip server
http://www.brekeke-sip.com/wiki/index.php?telepark.wiki=bc379d32 |
|
Back to top |
|
|